네티스 M1200AC 공유기에 OpenWRT를 올/140;보/140;고 시도1473;1077;니다.
UART 4핀1008; 땜1656;해서 ǥ12;트/196;더에 시리얼포트/196; 1217;근1060; .121;니다.

다만 1204;원켜고 2번 메뉴를 눌러 TFTP /196;딩1012; 시도Ȣ16;면 T T T T T T T 글1088;만 계속 찍7176;면서 6156;웨Ǻ12;를 6140;오1656; 못Ȣ16;lj16;군요.

윈도우10에서lj16; TFTPD64 라lj16; 프/196;그ǖ16;1012; 설치했고, 0169;화ǣ17;에서 1217;근포트를 풀Ǻ12;1452;었습니다.

무Ꮗ1;1012; 더 확1064;해봐야 할까요? 

=====================================================================================

Please choose the operation:

   1: Load system code to SDRAM via TFTP.

   2: Load system code then write to Flash via TFTP.

   3: Boot system code via Flash (default).

   4: Entr boot command line interface.

   9: Load Boot Loader code then write to Flash via TFTP.

You choosed 2                                                                                                                                                                        

2: System Load Linux Kernel then write to Flash via TFTP.

 Warning!! Erase Linux in Flash then burn new one. Are you sure?(Y/N)

 Please Input new ones /or Ctrl-C to discard

        Input device IP (192.168.0.170) ==:192.168.0.2

        Input server IP (192.168.0.171) ==:192.168.0.171

        Input Linux Kernel filename () ==:fw.bin

 netboot_common, argc= 3

 NetTxPacket = 0x87FE5BC0

 KSEG1ADDR(NetTxPacket) = 0xA7FE5BC0

 NetLoop,call eth_halt !

 NetLoop,call eth_init !

Trying Eth0 (10/100-M)

 Waitting for RX_DMA_BUSY status Start... done

 ETH_STATE_ACTIVE!!

TFTP from server 192.168.0.171; our IP address is 192.168.0.2

Filename 'fw.bin'.

 TIMEOUT_COUNT=10,Load address: 0x80100000

Loading: T T T T T T T T T T